1.7mhz ultrasonic mist maker atomizing transducer ceramic humidifier 230W

【Notice of use】
1．When the atomizer is working properly, please do not put your hand above the atomizer spray chamber so as to prevent ultrasonic injury.
2．Atomizer must be in water to work properly, before use, please put it into the water, then put on the power supply, and to ensure that the surface of the atomizing piece is in water condition, so as not to damage the atomizer.
3．Switch off the power before you use the nebulizer, then remove the nebulizer from the water.
4．When using this atomizer, please choose the output power greater than 300W, the output voltage is DCV45 + 5 power supply.
5．When more than one provided using the same container, the need to pay attention to the atomizer shell are communicated each other, which do not use water line design solution and the wafer produce potential difference (electrolytic atomizer casing itself has charged) to prevent the generation of electric corrosion work (electric spark corrosion).
6．The fog produced by the atomizer must be forced out by the fan, and each group of nebulizer keeps the plane space of the 350CM2, so as to avoid the water temperature being too high and shorten the service life of the atomizer.
7．Atomizer is not suitable for atomizing corrosive liquid, so as not to damage the atomizer, metal shell and atomizing piece.
8．Please do not damage the water level induction switch during the installation so as to avoid the malfunction of the water level switch and cause the atomizer to be out of control. After the water level switch is damaged, it should be stopped. Otherwise, the atomizing disc will be dry burned, thus further damaging the atomizer. At this point should be repaired by professional maintenance personnel can use the rear.